Vancouver, Canada - Tinka Resources Limited (the “Company”), (TSXV: TK) (Frankfurt: TLD) (OTCPK: TKRFF), announces an up-dated resource estimate for the Zone 1 silver deposit located within the Company’s 100 percent-owned Colquipucro project, central Peru.

Mr Carter said: “We are extremely pleased with the increase in the resource from a limited number of new drill holes. Infill drilling along existing lines, where data is missing, will likely provide additional resources. The Company is also applying for an amendment to the drill permit to test the contiguous area of surface mineralization to the northwest of the resource (see press release September 17, 2012).”

Two cut-off levels, 15 g/t Ag and 30 g/t Ag, and a rock density of 2.65 tonnes per cubic metre were used in this estimate. A total of 25 drill holes, 3 surface trenches and 2 underground workings were used in arriving at this resource estimate.

All samples from the phase 2 drilling program were delivered to SGS Laboratories in Lima, Peru by Company personnel. The samples were all tested for multi-elements using ICP technique following a multi-acid digestion. Silver values greater than 100 ppm (g/t) were re-analyzed using a gravimetric technique. The Company routinely inserted known standards and blanks with the samples submitted to the laboratory.

Zone 1 Inferred Resources, Silver
Cut-off     15 g/t Ag    15 g/t Ag    15 g/t Ag   30 g/t Ag  30 g/t Ag     30 g/t Ag
Category    Tonnes        Average     Contained    Tonnes     Average      Contained
                         Grade: g/t       Oz                 Grade: g/t       Oz.
                           (oz)                                (oz)
Sandstone   8,423,384   75.82 (2.21)  20,532,198  5,423,756 112.04 (3.27)  19,536,758
Lower Units 5,522,618   68.67 (2.00)  12,192,243  3,018,155 103.42 (3.02)  10,035,044
Global     13,946,002   72.98 (2.13)  32,724,441  8,441,911 108.95 (3.18)  29,571,802

Ten new holes were drilled during 2011-2012 in the “extension zone” immediately north of and contiguous with the Zone 1 deposit. This program successfully increased the inferred resource by almost 50%, from 20.3 million ounces to 29.6 million ounces, using a 30 g/t cut-off.

Due to the fairly wide spacing of data between section lines, all resources are still classified as inferred,as was the original estimate reported in 2008. An attempt at block modeling indicated that the data density is not sufficient for this method to produce a meaningful figure at this time; once in-fill drilling has been completed, a revised resource will be commissioned.

The Company’s qualified person, John Nebocat, P.Eng., has recently compiled this estimate in an updated NI43-101 report that will be filed under the Company’s profile on SEDAR at and on the Company’s website at Recommended infill drilling along existing section lines will likely provide additional resources where data is missing, and drilling along closer spaced lines should upgrade the resource from an inferred to indicated category.

The Company’s Qualified Person, John Nebocat (P.Eng.), has reviewed and approved the contents of this news release.

On behalf of the Board,

“Andrew Carter”
Andrew Carter, President & CEO Company Contact:
Mariana Bermudez at (604) 699 0202 or email:

Investor Information Contact:
Bay Street Connect
Michael D’Amico
Tel: 1.647.500.6023

Forward Looking Statements This Company Press Release contains certain “forward-looking” statements and information relating to the Company that are based on the beliefs of the Company’s management as well as assumptions made by and information currently available to the Company’s management. Such statements reflect the current risks, uncertainties and assumptions related to certain factors including, without limitations, competitive factors, general economic conditions, customer relations, relationships with vendors and strategic partners, the interest rate environment, governmental regulation and supervision, seasonality, technological change, changes in industry practices, and one-time events. Should any one or more of these risks or uncertainties materialize, or should any underlying assumptions prove incorrect, actual results may vary materially from those described herein.

Neither the TSX Venture Exchange, its Regulation Services Provider (as that term is defined in the policies of the TSX Venture Exchange), nor the Frankfurt Stock Exchange accepts responsibility for the adequacy or accuracy of this news release.

Subscribe for Updates